Duel Code 11.1v 1100mAh 25c T-Dean Battery

When structural space inside your rifle is at an absolute premium but you refuse to compromise on trigger performance, the Duel Code 11.1v 1100mAh 25c LiPo Stick Battery is the ultimate micro power solution. Purpose-built to feed demanding gearboxes, this high-voltage pack provides an instantaneous surge of power in a remarkably scaled-down form factor.

Ultra-Compact Footprint & High-Discharge Output Designed explicitly for modern CQB platforms, PDWs, and tight buffer tubes, this battery features highly optimized cells that minimize physical volume while retaining intense electrical performance. Despite its smaller 1100mAh capacity, its 25c continuous discharge rating means it effortlessly drives high-torque motors and upgraded spring sets. The 11.1v configuration forces your motor to cycle instantaneously, virtually rewriting your semi-automatic trigger response and heavily boosting your cyclic rate of fire.

Pre-Soldered T-Deans Efficiency To match the expectations of modern airsoft builds, this Duel Code battery features a high-efficiency T-Deans connector wired with premium flexible 16 AWG silicone cabling. By replacing restrictive legacy plugs with a large-surface-area Deans contact, electrical resistance across the loom drops dramatically. This prevents energy loss, reduces heat generation in your wiring, and ensures every bit of voltage goes straight into cycling your piston assembly.

Mosfet & Safety Requirements Due to the rapid energy transmission of an 11.1v LiPo setup, this battery is intended for use in AEGs equipped with an internal MOSFET or an Electronic Trigger Unit (ETU) to safeguard mechanical trigger contacts against electrical arcing. The pack is equipped with an industry-standard JST-XH balance lead alongside the primary power cable, allowing you to easily check and equalize individual cell voltages during maintenance.

Key Technical Features:

• High-Octane 11.1v 3-Cell Setup: Delivers a major upgrade to trigger snappiness and full-auto cyclic speed.

• Stable 25c Discharge Rate: Provides steady amperage to prevent motor stalling or cycle lag.

• Factory T-Deans Connection: Lower resistance means cooler running temperatures and better energy throughput.

• Micro Stick Form Factor: The perfect answer for tight M4 buffer tubes, folding stock hinges, and low-profile handguards.

• Integrated Balance Cable: Features a standard JST-XH layout for safe, balanced replenishment loops.

Safety, Charging & Storage Recommendations Lithium Polymer batteries must be managed with a specific set of rules to preserve safety and cell longevity. Never charge this pack using a NiMH or non-balancing charger; always use a dedicated LiPo balance smart charger. Do not let the battery run completely flat on the field; if you notice your rifle's rate of fire starting to slow down, replace the battery immediately. For off-season or long-term storage, keep the cells at a partial nominal charge (~3.8v per cell) inside a sealed, fire-resistant LiPo safety pouch in a climate-controlled room.